Epson TM-L90 Plus with Peeler Technical Reference Guide - Page 158
Die-cut label size, Black mark position for die-cut label paper
View all Epson TM-L90 Plus with Peeler manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
Die-cut label size When manufacturing die-cut label paper, be sure that the paper meets the following requirements. 25.4~279.4 Label length + L2 L2 = 3 ~ 10 Label Size Requirement Note: ❏ Be sure to set the cutting position (L4) between labels. ❏ Be sure that the distance from the cutting position to the print starting position (=L3-L4) is 2.75 mm {0.11"} or more. Black mark position for die-cut label paper If die-cut label with black marks is used, there are two reflective rate requirements, depending on the size and position of black marks. Be sure to use label paper that meets either black mark position requirement I or II as follows: 158 Appendix
158
Appendix
Die-cut label size
When manufacturing die-cut label paper, be sure that the paper meets the following
requirements.
Label Size Requirement
Note:
❏
Be sure to set the cutting position (L4) between labels.
❏
Be sure that the distance from the cutting position to the print starting position (=L3-L4) is 2.75 mm
{0.11"} or more.
Black mark position for die-cut label paper
If die-cut label with black marks is used, there are two reflective rate requirements, depending
on the size and position of black marks. Be sure to use label paper that meets either black mark
position requirement I or II as follows:
Label length + L2
L2 = 3
~
10
25.4
~
279.4