Epson WorkForce Enterprise WF-C21000 Users Guide - Page 66
Error code and message, Solution, Obtain IP Address, Manual, Obtain IP, Address
View all Epson WorkForce Enterprise WF-C21000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Error code and message Solution E-8 Incorrect IP address is assigned to the printer. Confirm IP address setup of the network device (hub, router, or access point). Contact your network administrator for assistance. If your product's Obtain IP Address setting is set to Auto, enable DHCP on your router or access point. If it is set to Manual, the IP address may be out of range or on a different network segment; set a valid IP address using your product control panel or the Web Config utility. You can also try turning off your product and the router or access point, waiting about 10 seconds, and turning them on again. E-9 Make sure your computer or network device are turned Confirm the connection and network setup of the PC or other device. Connection using the EpsonNet Setup is available. Contact on. Also make sure that you can access the Internet and other devices on the same network from the devices you are trying to connect to your product. your network administrator for assistance. If you still cannot connect to your product, turn off your router or access point, wait about 10 seconds, and turn it on again. Download and install your product software again to reset your network settings. E-10 Confirm IP address, subnet mask, and default gateway setup. Connection using the EpsonNet Setup is available. Contact your network administrator for assistance. Make sure other devices on the network are turned on and do the following: • If your product's Obtain IP Address setting is set to Manual, check the IP address, subnet mask, and default gateway addresses on the network connection report to see if they are correct. If not, correct the settings. • If DHCP is enabled, set your product's Obtain IP Address setting to Auto. If you want to use the DHCPassigned address as a static address, set the Obtain IP Address setting to Manual, enter the product's IP address as listed on the network connection report, and set the subnet mask to 255.255.255.0. If you still cannot connect to your product, turn off your router or access point, wait about 10 seconds, and turn it on again. 66