Fantec BeastVision XHD Standard Edition Manual - Page 20

d Self Shot

Get Fantec BeastVision XHD Standard Edition PDF manuals and user guides View all Fantec BeastVision XHD Standard Edition manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

b) Triple shot: Press "M" key to enter the camcorder setup interface, press ">"or "" key to move the cursor to " " and then press"+"or "-" key to select the menu "Continuous Shooting", and press "OK" key to set the continuous shooting interval time to 2s, 3s, 5s, 10s, 20s, 30s. Press "M" key to exit the setup interface. Press "Shutter" at this time, and the unit will start shooting one photo every 2s, 3s, 5s, 10s, 20s, 30s until you press "Shutter" key again to stop. d) Self Shot: Press "M" key to enter the camcorder setup interface, press ">"or "

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
20
b) Triple shot:
Press “M” key to enter the
camcorder
setup interface, press “>”or “<” key to move the
cursor to
“
”, and then press “+”or “
-
” key to select the menu “Three Photos Continuous Shooting”,
and press “OK” key
to confirm.
Press “M” key to exit the setup interface.
Pressing
“Shutter” once at
this time the unit will continuously shoot three photos.
c) Continuous shoot:
Press “M” key to enter the
camcorder
setup interface, press “>” key
to move the
cursor to “
” and then press“+”or “
-
” key to select the menu “Continuous Shooting”, and press “OK”
key
to set the continuous shooting interval time to
2s, 3s, 5s, 10s, 20s, 30s
. Press “M” key to exit the
setup interface. Press “Shutter” at this time, and
the unit will start shooting one photo every 2s, 3s, 5s,
10s, 20s, 30s until you
press “Shutter” key again to stop.
d) Self Shot:
Press “M” key to enter th
e camcorder
setup interface, press
“>”or “<”
key
to move the
cursor to “
”, and then press“+”or “
-
” key to select the menu “Self
-
timer”, and press “OK” key to set
the delay time as
5s or 10s. Press “M” key to exit the setup interface.
Press “Shutter”
once and the unit
will start the timer and take a single photo at the end of the delay time.
Note:
a) If the memory space gets full, the system will give the messa
ge “
card is full' on TFT display screen
and goes back to the preview mode
b) The self-timer has to be re-started in order to take another self-shot.