Frigidaire FFMV1645TH Installation Instructions - Page 18
Adapting Microwave, Blower For Outside, Back Exhaust Cont.
View all Frigidaire FFMV1645TH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Installation Instructions B5. ADAPTING MICROWAVE BLOWER FOR OUTSIDE BACK EXHAUST (cont.) 4 Rotate blower unit counterclockwise 180°. Before Rotation After Rotation 8 Place the blower unit back into the opening. AFTER: Fan Blade Openings Facing Back End A End B Back of Microwave Back of Microwave 5 Gently remove the wires from the grooves. Reroute the wires through grooves on other side of the blower unit. Before Rerouting After Rerouting Wires Routed Through Right Side Wires Routed Through Left Side 6 Roll the blower unit 90° so that fan blade openings are facing out the back of the microwave. Before Rolling After Rolling Back of Microwave Back of Microwave 7 Remove the knockout plates in the back of the unit with snips. (For some models) Knockout Plates: Snip all 4 webs on each knockout panel and remove the metal knockouts for rear airflow. Please take care to remove any sharp edges created from removing Back of mircrowave the knockout plates. CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched, and that they are properly secured. NOTE: The blower unit exhaust openings should match exhaust openings on rear of microwave oven. 9 Secure the blower unit to the microwave with the original screw. Blower Plate Back of Microwave Blower Motor Screw 10 Replace the blower plate in the same position as before with the screw. Make sure the screw is tight. 11 Attach the exhaust adaptor to the rear of the oven by sliding it into the guides at the top center of the back of the oven. Adaptor Back of Microwave Guide Guide Locking Tabs Push in securely until it is in the lower locking tabs. Take care to assure that the damper hinge is installed so that it is at the top and that the damper swings freely. EN-18