Frigidaire FFMV1645TH Installation Instructions - Page 24

NOTE: IT IS VERY IMPORTANT TO READ AND FOLLOW THE DIRECTIONS IN THE INSTALLATION INSTRUCTIONS BEFORE PROCEEDING WITH THIS REAR WALL TEMPLATE. This Rear Wall Template serves to position the bottom mounting plate and to locate the horizontal exhaust outlet. 1. Use a level to check that the template is positioned accurately. 2. Locate and mark at least one stud on the left or right side of the centerline It is important to use at least one wood screw mounted firmly in a stud to support the weight of the microwave. Mark two additional, evenly spaced locations for the supplied toggle bolts. 3. Drill holes in the marked locations. Where there is a stud, drill a 3/16" hole for wood screws. For holes that do not line up with a stud, drill 5/8" holes for toggle bolts DO NOT INSTALL THE MOUNTING PLATE AT THIS TIME. 4. Remove the template from the rear wall. 5. Review the Installation Instruction book for your installation situation. Darle vuelta a la hoja para consultar la versión en Español. Locate and mark holes to align with holes in the mounting plate. IMPORTANT: LOCATE AT LEAST ONE STUD ON EITHER SIDE OF THE CENTERLINE. MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY SPACED TOGGLE BOLTS IN THE MOUNTING PLATE AREA. Trim the rear wall template along the dotted line. Part No.:316902476  3/8" TO EDGE 12" 4" Trim the rear wall template along the dotted line.  Locate and mark holes to align with holes in the mounting plate. IMPORTANT: LOCATE AT LEAST ONE STUD ON EITHER SIDE OF THE CENTERLINE. MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY SPACED TOGGLE BOLTS IN THE MOUNTING PLATE AREA.    3/8＂ 3/8＂ 13-3/8＂ 3/8＂ 2＂ 1/2＂ Part No.:316902475 4-1/2＂ 8-1/4＂ 13-3/8＂ 3/8＂ 3/8＂ 3/8＂ 3/8＂ 9-27/32＂ 2＂ 2＂ 12-1/2＂ 6-1/4＂ 4-1/4＂ PN: 261800320116 EN-24 Printed in China