Frigidaire FFMV1645TH Installation Instructions - Page 32
AlineaciÓn De La Placa Para La Pared
View all Frigidaire FFMV1645TH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Instrucciones de instalación D. ALINEACIÓN DE LA PLACA PARA LA PARED NOTE: IT IS VERY IMPORTANT TO READ AND FOLLOW THE DIRECTIONS IN THE INSTALLATION INSTRUCTIONS BEFORE PROCEEDING WITH THIS REAR WALL TEMPLATE. This Rear Wall Template serves to position the bottom mounting plate and to locate the horizontal exhaust outlet. 1. Use a level to check that the template is positioned accurately. 2. Locate and mark at least one stud on the left or right side of the centerline. It is important to use at least one wood screw mounted firmly in a stud to support the weight of the microwave. Mark two additional, evenly spaced locations for the supplied toggle bolts. 3. Drill holes in the marked locations. Where there is a stud, drill a 3/16" hole for wood screws. For holes that do not line up with a stud, drill 5/8" holes for toggle bolts. DO NOT INSTALL THE MOUNTING PLATE AT THIS TIME. 4. Remove the template from the rear wall. 5. Review the Installation Instruction book for your installation situation. Darle vuelta a la hoja para consultar la versión en Español. 3/8" TO EDGE 12" 4" Locate and mark holes to align with holes in the mounting plate. IMPORTANT: LOCATE AT LEAST ONE STUD ON EITHER SIDE OF THE CENTERLINE. MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY SPACED TOGGLE BOLTS IN THE MOUNTING PLATE AREA. Muescas de la Agujero B línea de centro Trim the rear wall template along the dotted line. Dibula Locate and mark holes to align with holes in the mounting plate. IMPORTANT: LOCATE AT LEAST ONE STUD ON EITHER SIDE OF THE CENTERLINE. MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY SPACED TOGGLE BOLTS IN THE MOUNTING PLATE AREA. una Inea vertical en la pared desde el centro del cumbre del armario. PRECAUCIÓN: para evitar cortes por los bordes afilados. La línea horizontal Área E 1 Trace una línea vertical en la pared, en el centro del espacio cuyo ancho es 30". 2 Trace una línea horizontal en la pared desde el fondo de "Plantilla de pared posterior." 3 Encuentre un travesaño en el área E de la placa de montaje. Consulte la sección 1B: Encontrar travesaños de pared. 4 Para adherir la placa de montaje al travesaño taladre un agujero de 3/16''. Taladre un agujero de 5/8'' para tornillo acodado en otra ubicación (Agujero A o Agujero B). NOTA: NO INSTALE LA PLACA EN ESTE MOMENTO. Agujero A La línea horizontal C Trace una línea horizontal en la pared desde el L fondo de "Plantilla de pared posterior". NOTA: Los Agujero A y los Agujero B se encuentran dentro de la regin E. Si tanto el agujero C como el D no quedan en una viga, localice una viga en el área E y trace un quinto círculo que quede alineado con la viga. Es importante que al menos un tornillo para madera quede fijado firmemente a una viga, a fin de que pueda soportar el peso del microondas. Deje a un lado la placa de instalación. SP-8