Frigidaire FFMV1645TH Installation Instructions - Page 21
Mount The Microwave Oven, Use Top Cabinet Template, For Preparation Of Top, Cabinet
View all Frigidaire FFMV1645TH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Installation Instructions C2. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET You need to drill holes for the top support screws and a hole large enough for the power cord to fit through. C4. MOUNT THE MICROWAVE OVEN • Read the instructions on the TOP CABINET TEMPLATE. • Tape it underneath the top cabinet. NOTE: Adjust top template accordingly if the microwave is being spaced out from the wall due to cabinet depth (including cabinet doors) of more than 13'" '. • Drill the holes, following the instructions on the TOP CABINET TEMPLATE. CAUTION: Wear safety goggles when drilling holes in the cabinet bottom. C3. CHECK BLOWER PLATE Blower Plate FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE INSTALL THIS MICROWAVE OVEN. IMPORTANT: Do not grip or use the handle or heat shield during installation. Do not remove the cardboard spacers between the heat shield and door. NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord. NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf. IMPORTANT: If filler blocks are not used, case damage may occur from overtightening screws. NOTE: When mounting the microwave oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1-3. Do not pinch cord or lift oven by pulling cord. 1 Lift microwave, tilt it forward, and hook slots at back bottom edge onto four lower tabs of mounting plate. • Place the microwave in its upright position, with the top of the unit facing up. • Check to see that the blower plate is correctly installed on the unit. 2 Rotate front of oven up against cabinet bottom. 3 Insert a self-aligning screw through top center cabinet hole. Temporarily secure the oven by turning the screw at least two full turns after the threads have engaged. (It will be completely tightened later.) Be sure to keep power cord tight. Be careful not to pinch the cord, especially when mounting flush to bottom of cabinet. Cabinet Front Cabinet Bottom Shelf Filler Block Equivalent to Depth of Cabinet Recess Self-Aligning Screw EN-21 Microwave Oven Top 4 Attach the microwave oven to the top cabinet.