Frigidaire FGIF3061NF Use and Care Guide - Page 12
Induction Cooking Zones, Important
View all Frigidaire FGIF3061NF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
INDUCTION COOKING ZONES Cooktop display windows The range backguard provides a digital window for each of the cooking zones located on the cooktop. Power levels and messages are easily monitored and controlled using the window displays in combination with the corresponding control knobs. Available power level settings The cooktop control (Fig. 1) will display power levels ranging from Pb (power boost, Fig. 2), Hi (Fig. 3) to Lo (Fig. 4). The settings between 9.5 (Fig. 5) and 1.5 (Fig. 7) decrease and increase in 0.5 increments. Use the "Suggested cooking zone power level settings table" provided in Setting Surface Controls section to determine the correct power level setting for the type of food you are preparing. Pb (Power Boost) power level When setting an induction cooking zone for Hi, the display will initially show Pb (Power Boost) power level for up to 10 minutes (See Fig. 1). After 10 minutes the cooking zone will automatically return to the Hi (Fig. 3) setting. The Pb setting is only available immediately after activating a cooking zone by turning the knob to Hi. (HE) Hot surface window message After using an induction cooking zone, the cooktop may become very hot. After turning any cooking zone OFF, the cooktop may remain HOT for some time. The corresponding HE (hot element - Fig. 8) message will remain ON until the cooktop has cooled. ESEC Error Indicator Message (Er) An error message will be displayed (flashing "Er") (Fig. 6) at power up (or after a power failure) if ANY of the surface control knobs were left in the ON positions. If a power failure should ocur, be sure to set all of the 4 surface control knobs to the OFF position (See Fig. 1). This will reset the surface controls. Be sure to reset the clock (See page 19). Once the surface controls have been set to the OFF positions and the clock has been set with the correct time of day, the surface controls should return to normal operation. If the surface controls do not function and the "Er" message remains in any display after following these procedures, contact an authorized servicer for assistance. (- -) Lockout window message The (- -) message will appear whenever the Lockout, Selfclean or Sabbath feature is active (See Fig. 9). Refer to the Lockout instructions for more details. Fig. 1 Fig. 2 Fig. 4 Fig. 3 Fig. 5 Fig. 6 Fig. 7 Fig. 8 Fig. 9 IMPORTANT The induction cooking zones will not operate when the oven is set for Sabbath mode. For more details on the Sabbath feature, see Setting Oven Controls section. 12