Fujitsu 4340C Operator's Guide - Page 67
Contents of the Setup Mode, Description, Selectable, parameters, Default - imprinter
UPC - 097564304156
View all Fujitsu 4340C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Contents of the Setup Mode This section describes the contents of the setup mode. No Item Description Selectable parameters Default 1 Specifies the double feed detection. Double feed check Double feed is detected by checking the document length and/or paper No/Yes No thickness.(*1) 2 Length check =No/10/15/20 mm Specifies the document length to enable double feed detection sets the document length. Tolerance: No/10/15/20mm No 3 IPC pre-setting Scanner automatically sets the recommended reading parameters. 3 sets of parameters are available when IPC-4D is not installed. Document: No 1: Sharpen 2: Darken Character 3: Copy Quality No 4 Resetting of abrasion counter Resets the abrasion counter. --- --- 5 Pick start time setting Specifies the time from document Insertion to the start of picking. User can select the most comfortable Pick start time for the job. Time: 0.2 to 29.8 sec 1.0 sec 6 Specifies the time the scanner waits for Time: Time-out limit setting the next document insertion after the last 27 values from document was scanned. 1 to 1999 sec 30 sec 7 ADF front offset setting(*2) Specifies the horizontal and vertical offset Offset: of the front side image when using the H:-2 to +3 mm ADF. V:-2 to +3 mm Offset: H: 0 mm V: 0 mm 8 ADF back offset setting(*2) Specifies the horizontal and vertical offset Offset: of the back side image when using the H:-2 to +3 mm ADF. V:-2 to +3 mm Offset: H: 0 mm V: 0 mm 9 Document bed offset setting(*2) Horizontal and vertical offset of the FB image is specified. Offset: H:-2 to +3 mm V:-2 to +3 mm Offset: H: 0 mm V: 0 mm 10 Displays whether or not the image IPC status display processing board (IPC-4D) and the --- --- Imprinter option are installed. 11 Low Power Mode Changes the default setting of the duration 5 min. setting for power save. to 60 min. 15 min. 12 Select Interface Selects the interface when the scanner has a board in the third party Slot. Auto/SCSI/Tps Auto 13 Display TPS Board ID Number Displays the ID number of the board which is installed in the third party Slot. --- --- G 7-3