Fujitsu 4340C Operator's Guide - Page 91
Reading Mode Setting When the VIDEO INTERFACE BOARD is Installed
UPC - 097564304156
View all Fujitsu 4340C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
I Reading Mode Setting When the VIDEO INTERFACE BOARD is Installed This section describes the button specifications and setup details for reading modes when the scanner has the VIDEO INTERFACE BOARD in the third party slot. When the reading mode is set by the command from the host computer, the following button operation is not required. NOTICE When the VIDEO INTERFACE BOARD is installed in the scanner, the scanner automatically recognizes the board and changes the display. Whenever you press , the scanner returns to screen M1. 1. Turn the power On and verify that "Scanner Ready" is displayed on the LCD. Screen M1 Re a d y XXXX XXXXX0 > 2. Press then the scanner displays Screen M2. Screen M2 Mo d e Sel e c t 0 Re a d i n g Mo d e 3. Press then the scanner displays Screen 1. Screen 1 01 I = A DF / ma g e FB So r r ce 4. Select ADF or FB by pressing Screen 2 or then press . The scanner displays Screen 2. 02 Re a d i = Si mp l ex / ng f Du p l ac e ex 5. Select "Simplex" or "Duplex" by pressing Screen 3. Screen 3 or . Then press Enter. The scanner displays 03 Or i ent at i on = Po r t / Land G 9-5