Fujitsu 6130 Getting Started Guide - Page 18

Appendix2 DAILY CARE CAUTION When operating the scanner, the ADF's inside glass becomes very hot. Before you clean inside the scanner, turn off its power and unplug the AC adapter from the outlet. Wait for at least 15 minutes. Turn on the scanner when you clean the Feed rollers or Eject rollers. WARNING Do not use any aerosol sprays or alcohol based sprays to clean the scanner. Dust blown up by strong air from the spray may enter the inside of the scanner. This may cause the scanner to fail or malfunction. Sparks, caused by static electricity, generated when blowing off dust and dirt from the outside of the scanner may cause a fire. ■ Cleaning Materials Cleaning Materials Parts Number Remarks Cleaner F1 PA039500352 1 bottle Moisten the cloth with this fluid and wipe the scanner clean. (*1) Cleaning wipe PA03950- 24 sheets per pack 0419 (*1)(*2) Lint-free dry cloth - Commercially available one *1: For details about the cleaning materials, contact the FUJITSU scanner dealer where you purchased the scanner. *2: Pre-moistened with Cleaner F1, Cleaning Wipes are used instead of moistened cloths. ■ Locations and Cycle for Cleaning Part to clean Brake Roller Pick roller Feed rollers Plastic rollers Eject rollers Glass Standard Cleaning Cycle Clean these parts after every 5,000 sheets. ATTENTION The scanner must be cleaned more frequently if you scan any of the following type of sheets: • Documents of coated paper • Documents that are almost completely covered with printed text or graphics • Chemically treated documents such as carbonless paper • Documents containing a large amount of calcium carbonate • Documents written by pencil • Documents on which the toner is not fused sufficiently. For details on cleaning the ADF, refer to section 4.3 "Cleaning the ADF" of "fi-6130/fi-6230 Operator's Guide" on the Setup CD-ROM. ■ Cleaning Method The ADF must be cleaned with a lint-free cloth moistened with the Cleaner F1. ATTENTION It may take long before the cleaner vaporizes if a large quantity is used. When cleaning the scanner parts, dampen a cloth with modest quantities of the cleaner. In addition, wipe off the cleaner completely with a soft lintfree cloth to leave no residue on the surface of the cleaned parts. AP-2