Fujitsu Fi-4750c Operating Guide - Page 90
Serial interface, SETUP mode, Simplex reading mode, Smoothing, Temporary Error, Terminator - scsi connector
UPC - 097564303531
View all Fujitsu Fi-4750c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Serial interface A standard computer interface. Information is transferred between devices over a single wire (although other wires are used for control). With a serial interface, an interface cable greater than 3 meters (10 feet) can be used. This is often necessary in networking environments, where the scanner may be shared. SETUP mode In this mode, users can view or set a variety of function in off-line. Simplex reading mode Only the front side of the document is read in this mode. Place the documents face up at the center of the hopper table. Smoothing A process that eliminates "jaggies" from slanted lines and curves. Irregular convexities are deleted and irregular concavities filled in. This is useful in OCR applications, for example. Temporary Error An error correctable by the operator. Terminator Devices with a SCSI interface can be daisy-chained. A resistor that includes terminal circuits needs to be placed at both ends of a cable when devices are daisy-chained. If a device (such as a scanner) is the last device in a chain, leaving an interface connector unused, a Terminator theerfore must be attached to provide those terminal circits. Third Party Interface Optional board provided by Fujitsu or interface board provided by a third party can be installed and used. Time-out limit This is the time the scanner waits for next document insertion after the last document feeding. The scanner returns Paper Empty when no document is set after time-out limit. TPS Third Party Slot. GL-5