Fujitsu P50XHA10 User Manual - Page 20
Selecting Input Mode
View all Fujitsu P50XHA10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
SELECTING INPUT MODE VIDEO INPUT MODE 1 Press the - buttons to select the input mode. You can select from VIDEO1 mode to VIDEO4 mode. The video modes corresponding to each input terminal are as follows. • VIDEO1: Video • VIDEO2: S-video • VIDEO3: Component video • VIDEO4: Component video Video1 mode * For selection of the input terminal, see "SETTING THE INPUT TERMINALS" on P. E-35. * You can also use the buttons on the display's control panel to perform these steps. RGB INPUT MODE 1 Press - input mode. to select the You can select between the modes from RGB1 to RGB2. The input terminal of each RGB mode is as follows. • RGB1: DVI-D • RGB2: mD-sub RGB1 mode E-20
E-20
SELECTING INPUT MODE
RGB INPUT MODE
1
RGB1 mode
Press the
–
buttons to
select the input mode.
You can select from VIDEO1 mode to VIDEO4
mode.
The video modes corresponding to each input
terminal are as follows.
•
VIDEO1: Video
•
VIDEO2: S-video
•
VIDEO3: Component video
•
VIDEO4: Component video
* For selection of the input terminal, see
“SETTING THE INPUT TERMINALS” on
P. E-35.
1
* You can also use the buttons
on the display’s control
panel to perform these steps.
VIDEO INPUT MODE
Video1 mode
Press
–
to select the
input mode.
You can select between the modes from RGB1 to
RGB2.
The input terminal of each RGB mode is as
follows.
•
RGB1: DVI-D
•
RGB2: mD-sub