Ganz Security ZN1A-B4DMZ56U-1 GXi Series VCA Interface Manual - Page 44
Step 2: Adjust tilt angle and camera height, Apply the changes
View all Ganz Security ZN1A-B4DMZ56U-1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Ganz GXi Series VCA Interface Manual V3.05.31.18 Step 2: Adjust tilt angle and camera height Now, adjust the camera tilt angle and vertical field of view until both mimics are approximately the same size as a real person at that position in the scene. If an estimated height is entered, then adjust this along with the other two parameters. Click and drag the ground plane to change the tilt angle, use the mouse wheel to adjust the camera height and drag the slider to change the vertical field of view. The 3 calibration parameters will be reflected in the edit boxes in the Camera Setup section of the web page. Apply the changes: Once the changes have been applied, the Calibration Status reflects whether the operation was successful, and if so, in which mode the camera is calibrated. 05-2018-A 43 | P a g e