Garmin Zumo 550 Owner's Manual - Page 10

A To install the U-bolt and handlebar - installation

Get Garmin Zumo 550 - Motorcycle GPS Receiver PDF manuals and user guides
UPC - 753759061753
View all Garmin Zumo 550 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

Getting Started A) To install the U-bolt and handlebar base: 1. Place the U-bolt around the handlebar, and thread the ends through the handlebar base. 2. Tighten the nuts to secure the base. Do not overtighten. Handlebar base U-bolt Note: The recommended torque is 50in-lb. Do not exceed maximum torque of 80in-lb. Handlebar B) To install the handlebar base to the clutch/brake clamp bracket: Note: Both 1/4" standard and M6 bolts are included. Match the size of the factory bolts on your clutch/brake clamp bracket. Handlebar base Clutch/brake clamp bracket 1. Remove the two factory bolts on your clutch/brake clamp bracket. 2. Thread the new bolts through the handlebar base, spacers, and clamp bracket. Spacers 3. Tighten the bolts to secure the base.  zūmo 500/550 Owner's Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
µ
zūmo 500/550 Owner’s Manual
G
ETTING
S
TARTED
A) To install the U-bolt and handlebar
base:
1. Place the U-bolt around the handlebar,
and thread the ends through the handlebar
base.
2. Tighten the nuts to secure the base. Do
not overtighten.
NOTE:
The recommended torque
is 50in-lb. Do not exceed maximum
torque of 80in-lb.
B) To install the handlebar base to the clutch/brake clamp bracket:
NOTE:
Both 1/4” standard
and M6 bolts are included.
Match the size of the
factory bolts on your
clutch/brake clamp bracket.
1. Remove the two factory bolts
on your clutch/brake clamp
bracket.
2. Thread the new bolts through
the handlebar base, spacers,
and clamp bracket.
3. Tighten the bolts to secure the base.
Handlebar
base
Handlebar
U-bolt
Clutch/brake
clamp bracket
Handlebar
base
Spacers