Gateway E-9232T Gateway E-9232T Server User Guide - Page 64
Beep codes, Beeps, Description, Troubleshooting steps
View all Gateway E-9232T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
CHAPTER 6: Troubleshooting Beep codes Beeps 1 2 3 4 5 6 7 8 9 10 11 Whenever a recoverable error occurs during the power-on self-test (POST), the BIOS displays an error message that describes the problem. The BIOS also sounds a beep code (one long tone followed by two short tones) during POST if the video configuration fails (a faulty video controller) or if an expansion card is not functioning correctly. One short beep indicates the BIOS will boot the operating system. No error found. A PCI expansion card (for example, a RAID controller) can also issue audible errors by itself, usually consisting of one long tone followed by a series of short tones. For more information on the beep codes issued, check the documentation for that device. The following table shows POST error beep codes. Prior to system video initialization, BIOS uses these codes to inform you of error conditions. Description Troubleshooting steps Memory refresh timer error Reseat the memory modules or replace with modules you know are good. Parity error in the first 64 KB of memory. Same as for 1 beep. Base memory read/write test error Same as for 1 beep. System board timer not operational. Possible system board malfunction. To eliminate the possibility of an add in-card problem, remove all expansion cards. If the beep code occurs even when all expansion cards have been removed, the system board is at fault. If the beep code does not occur when the expansion cards have been removed, one of the cards is causing the problem. Install the cards one at a time until the problem happens again. When the beep code returns, the most recent card you installed is at fault. A processor on the system board generated an error. Remove one of the processors if two are installed, then try a known good processor in the first socket. Same as for 4 beeps. The keyboard controller (8042) may be defective. The BIOS cannot switch to Protected mode. Remove the keyboard to see if the error goes away. If it does, try a known good keyboard. Same as for 4 beeps. General exception error (processor exception error). Same as for 5 beeps Display memory error (system video adapter). If the system video adapter is an add-in card, replace or reseat the video adapter. If the video adapter is integrated into the system board, the board may be faulty. Try using an add-in card. The ROM checksum value does not match the Same as for 4 beeps. value encoded in the BIOS. The shutdown register for CMOS RAM failed. Same as for 4 beeps. The cache memory test failed. Same as for 4 beeps. 58