GE GTW810SSJWS Use and Care Manual - Page 3
Save These Instructions - parts
View all GE GTW810SSJWS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
GEAppliances.com PROPER INSTALLATION This washer must be properly installed and located in accordance with the Installation Instructions before it is used. If you did not receive an Installation Instructions, you can receive one by visiting GEAppliances.com or by calling 800.GE.CARES (800.432.2737). In Canada, visit www.geappliances.ca or call 800.561.3344. Ensure that the hot water hose is connected to the "H" Optional drain hose extension recommended for valve and the cold water hose is connected to the "C" discharging heights from 60" - 96". valve. Install or store where it will not be exposed to temperatures below freezing or exposed to the weather, which could cause permanent damage and invalidate the warranty. Properly ground washer to conform with all governing codes and ordinances. Follow details in Installation Instructions. This washer does not include water supply hoses. GE strongly recommends the use of factory specified parts. A list of factory hoses available for purchase are listed. These hoses are manufactured and tested to meet GE specifications. GE strongly recommends the use of new water supply hoses. Hoses degrade over time and need to be replaced every 5 years to reduce the risk of hose failures and water damage. WARNING - Electrical Shock Hazard Parts and Accessories Plug into a grounded 3 prong outlet. DO NOT remove ground prong. Order on-line at GEApplianceparts.com today, 24 hours a day or by phone at 800.626.2002 during normal business DO NOT use an adapter. DO NOT use an extension cord. hours. In Canada, visit your local GE parts distributor or call 800.661.1616. Failure to follow these instructions can result in death or electrical shock. Part Number PM14X10002 Accessory 4 ft rubber water supply hoses Or PM14X10005 4 ft braided water supply hoses WH49X301 Drain hose extension DR07X10005 6' Cable - CleanSpeak™ communication PBX10W00Y0 WiFi ConnectPlus module ¥ FUNCTIONALITY CHECK If the lid is opened between cycles (i.e. not pausing and restarting the current cycle, changing cycles after it started, etc.) pushing the Start button will cause the washer to turn on the cold water for 5 seconds followed by a 10 second delay before locking the lid and starting the cycle. If the lid is opened during this 15 second period, the word PAUSE will start scrolling across its display. You will have to push the Start button again to restart the cycle. WHEN NOT IN USE Turn off water faucets to minimize leakage if a break or rupture should occur. Check the condition of the fill hoses; GE recommends changing the hoses every 5 years. SAVE THESE INSTRUCTIONS 3