GE JGB900 Owners Manual - Page 33

Usea sewing needle or twist-tie to unclog flTesmall hole in flTe burner head. ge.com Burner Caps and Heads NOTE:Beforeremovingtheburnercaps and heads,remembertheirsizeand location. Replacethemin thesamelocationafter cleaning. Burner caps I,ifl off when cool. _.V_sh burner caps in hot, soapy water and rinse with clean water: You may scour with a plastic scorning pad u) renlove bm'ned-on toed particles. Burner heads For i)roi)er ignition, make sm'e tile small hole in tile section that fits over tile electrode is kept open. A sewing needle or wire twist-tie works well to tmclog it. Theslits in the burner heads must be kept clean at a// times. Clogged or dirty 1)/m_er ports or electrodes will not allow file b/m_er to operate properl): An) spill on or are/rod an electrode must be carefifllv cleaned. %_ke care to not hit an electrode with anything hard or it could be damaged. You should clean tile bm'ner caps and bm'ner heads routinely, especially alter bad spillove_s, which could clog the openings in tile bm'ner heads. I.ifi offwhen cool. To remove burned-on fi)od, soak tile burner heads in a solution of mild liquid (lete_gent and hot water lot 20-30 minutes. For illoi'e Sttlbboi'n stains, rise a toothbrtlsh. After cleaning Before putting tile bm'ner caps and heads back, shake out excess water and then (h_' them thoroughly by setting in a warm oven ti)r 30 minutes. NOTE"Donot usesteel woolorscouringpowders tocleantheburners.Thiscandamagetheburners andelectricallyshorttheelectrodes. Replacement Rei)lace bm'ner heads over tile ele(trodes on the cooktop, in tile correct locations according to flmir size. Mediumhead Smalhl ead Largehead o Extralargehead Make sm'e tile slot in tile burner head is positioned over the electrode, Rei)lace tile matching size caps onto the heads. Mediumcap o Smalcl ap •°- ....... Fronot f range Largecap Extra largecap Make sm'e that tile heads and caps are replaced in the correct locations. I i!!!iliii /iiilliiii{iii_ m =: g g } 33