GE JGB900 Owners Manual - Page 38

Care and cleaning of the range. Oven Shelves If your o',en is equipped with nickel oven shelves, they should be remo\vd fl'om tile oven befiwe beginning tile seltXclean cycle. To clean tile nickel sheers, use all abrasive cleanse*: Mter cleaning, rinse the sheers with clean water and dIw with a clean cloth. If the sheers e\vr become haM to slide, wipe tile shelf edges or oven shelf supports with vegetable oil. If your o\vn is equipped with gray porcelaincoated shelves, they mm be cleaned in tile oven chMng tile selgclean cycle. They may also be cleaned by using all abrasive cleanse_: _Mter cleaning, rinse tile shelves with clean water and chw with a clean cloth. If tile shelves e',vr _)ecome hard to slide, wipe the shelf edges or o\vn shelf supports with vegetable oil. ii; Wire cover holder. Oven Light Replacement ¸:: CAUTION: Beforerep/aclbg your ovenhgbt bulb, disconnectthe e/ectncai power to the rangeat the male fuse or ckcuit breaker pane/.Be sure to iet the i ii iii iiiiii iight cover and buib coo/compiete/y Tile oxen light bulb is coxered with a remox:O_le glass cover that is held in place with a bail-shaped wire. Remove the oven dora; if desired, to reach cover easily: TO remove." [_] Hold a hand under tile co;er so it ii i doesn't tifll when released. X,_ith fingeI_ of tile salne hand, finnl} push back tile wire coxer holdei: Lift off the COX er, Do not remove any screws to remove the cover. ] Do not touch hot bulb with a wet cloth. Replace bulb with a 40-watt household appliance bulb. Toreplace cover: [] Place it into the groove of the light receptacle. Pull the wire torward to the center of tile cover until it snaps into place. _]lell ill place, tile wire holds tile cover fiI_nh'. Be certain tile wire is in the depression in the center of tile cover. [] Connect electrical power to tile range. 38