GE JVM1790SK Service Manual - Page 17
B. Removing Oven From Wall, Persons Required, C. Removing The Out Case
UPC - 084691123453
View all GE JVM1790SK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
B. REMOVING OVEN FROM WALL (2 PERSONS REQUIRED) Oven is hooked on metal tabs at bottom of wall mounting plate and fastened to cabinet by (3) top cabinet bolts. CAUTION: Oven weights 77 lbs. Requires 2 persons for removal C. REMOVING THE OUT CASE(Figure 8) (1) Remove the vent grille by removing two screws securing it to the out case. (2) Remove two screws securing it to the air duct. (3) Remove the base plate by removing four screws securing it to the out case. Remove the Mount, All from the out case by removing two screws securing it to the out case. (4) Remove four screws from the rear section. (5) Remove the outcase with pushing it back. (6) Remove the outcase with disconnecting power cord connector. 1. Disconnect Power Cord, Top exhausted models disconnect duct and remove damper assembly. 2. Remove (3) top cabinet bolts while supporting unit. 3. Lift off back hooks and pull unit forward slowly providing adequate support to prevent dropping unit during removal. Mount,All Door Vent Grille (1 or 2 screws) Mounting Plate Out Case Controller Figure 8 7-6 (3 screws)