GE JVM1790SK Service Manual - Page 24
Test The Latch And Switch Sequence, Test The Microwave Energy Leakage - fuse
UPC - 084691123453
View all GE JVM1790SK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
TEST THE LATCH AND SWITCH SEQUENCE (5) Open the oven door slowly. Watch the door latch, the Secondary Switch. Release Rod and Lever on the switches to make sure they are zero to the body of the switches in the following sequence: - Primary Interlock Switch - Secondary Interlock Switch - Interlock Monitor Switch Adjust the latch board until the switches operate in this sequence. See Steps 3 and 4. (6) Close the oven door slowly and be sure it is tightly closed. Watch the three switches to make sure they are zero to the body of the switches in the following sequence: - Interlock Monitor Switch - Secondary Interlock Switch - Primary Interlock Switch NOTE: The Interlock Monitor Switch is an added safety check on the Primary and Secondary Interlock Switches. If the Primary and Secondary Interlock Switches allow the oven to operate with the door open, the Monitor Switch will blow the fuse. (7) When you achieve the proper sequence of switches in Steps 5 and 6, tighten the latch board screws at that point. TEST THE MICROWAVE ENERGY LEAKAGE Make sure the microwave energy leakage is below the limit of 1mW/cm2 (with a 275 ml water load) and 5mW/cm2 (with a 275 ml water load without the cabinet) when measured with a survey meter. 7-13