GE JXGB90S Use and Care Manual - Page 29
Final Assembly
UPC - 084691143420
View all GE JXGB90S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Installation Instructions FINAL ASSEMBLY 17 ASSEMBLE THE COOKTOP Install the sealed burner module, caps and grate on the right side of the unit. See page 10 for correct installation. 18 INSTALL GREASE JAR, DOWNDRAFT FILTER AND VENT GRILLE Screw the grease jar into the grease jar holder on the bottom of the cooktop. Install the optional sealed burner module or the grill/griddle burner on the left side of the unit. If the grill/griddle burner was installed, place the grill grate or griddle cover over it as desired. NOTE: The grill and griddle can be installed on the left side only. or Do not operate the vent without the filter in place. Place the filter through the vent opening. Make sure it rests, at an angle, on the supports in the vent opening. Latch it in place. Check for proper ignition: Push in one control knob and turn to LITE position. The igniter will spark and the burner will light; igniter will cease sparking when the burner is lit. First test may require some time while air is flushed out of the gas line. Turn knob to OFF. Repeat the procedure for each burner. Adjust the air shutters (see LP Conversion Instructions). Adjust the low flame setting (see LP Conversion Instructions). Place the vent grille onto the downdraft opening so that the open part of the grille is toward the rear of the unit. Grille CHECK OPERATION OF DOWNDRAFT Turn the vent fan speed control to HI, MED and LO 29 to make sure all speeds operate correctly.