GE PP9830SJSS Use and Care Manual - Page 19

INSTALLATION INSTRUCTIONS Installation Instructions UNPACKING THE COOKTOP/INSTALLING THE GASKET 8 INSTALLING THE FOAM GASKET Do not install the cooktop into the countertop without installing the foam gasket as shown. It protects the bottom edge of the glass from the countertop and seals the cooktop against spills. Remove the cooktop along with its shipping pad from the shipping box. Remove the shipping block from the downdraft vent opening and place it under the shipping pad to provide level support. Center vent shipping block - place under the shipping pad to provide level support CAUTION: GLASS IS FRAGILE. DO NOT BUMP EDGE OF GLASS DURING INSTALLATION. Locate the reflective tape and foam gasket tape included with your cooktop. Foam Gasket Installation Notes: • The foam gasket tape should be installed within 1/8" of the edge of the glass. Do not stretch or twist the foam gasket tape. CAUTION: Failure to install foam gasket tape greatly increases the potential of breaking the cooktop glass when installing, especially in Corian® or granite countertops. • Use care not to stretch the foam gasket tape while it is installed or it will not stay in place. • Do not place foam gasket tape over the metal flanges. • Butt the foam gasket tape ends together at each corner without overlapping. • Trim the foam gasket tape to length without stretching. • Mitre cut outside corners of foam gasket tape slightly if necessary for appearance. Peel off the white backing to install the foam gasket tape on the bottom side of the cooktop glass as shown. Underside of Glass Foam Gasket Tape 1ø8" max. to Glass Edge • Do not scratch the glass while cutting the foam gasket tape. 49-80635-1 19