GE WSSH300GWW Owners Manual - Page 12
Installation Instructions, LOCATION OF YOUR WASHER, ROUGH-IN DIMENSIONS - stacking kit
UPC - 084691158936
View all GE WSSH300GWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Installation Instructions LOCATION OF YOUR WASHER Do Not Install the Washer: 1. In an area exposed to dripping water or outside weather conditions. The ambient temperature should never be below 60°F (15.6°C) for proper washer operation. 2. In an area where it will come in contact with curtains or drapes. 3. On carpet. The floor MUST be a hard surface with a maximum slope of 1/2″ per foot (1.27 cm per 30 cm). To make sure the washer does not vibrate or move, you may have to reinforce the floor. IMPORTANT: Minimum Installation Clearances • When installed in alcove: Sides, Rear, Top = 0″ (0 cm) • When installed in closet: Sides, Rear, Top = 0″ (0 cm), Front = 1″ (2.54 cm) • Closet door ventilation openings required: 2 louvers each 60 square in. (387 cm2), located 3″ (7.6 cm) from top and bottom of door Undercounter Installation If an undercounter installation is desired, a custom-sized countertop is required (36″ to the underside of the countertop). No special washer top is required. Mobile Home Installation Installation must conform to Standard for Mobile Homes, ANSI A119.1 and National Mobile Home Construction and Safety Standards Act of 1974 (PL93-383). Stacked Installation If a stacked washer/dryer installation is desired, you MUST use Stacking Kit WE25X10020. This kit is available through your GE retailer. ROUGH-IN DIMENSIONS 33⁄4″ (9.5 cm) 273⁄4″ (70.5 cm) 24″ (61 cm) 60″ (152.4 cm) Power Cord 333⁄8″ (84.8 cm) SIDE 81⁄2″ (21.6 cm) 36″ (91.3 cm) 23⁄4″ (7 cm) Drain 321⁄4″ (81.9 cm) 27″ (68.6 cm) 63⁄4″ (17.1 cm) Water Inlets 331⁄2″ (85.1 cm) REAR 12