GE WSSH300GWW Owners Manual - Page 9

Operating Instructions, Dispenser Drawer Area - replacement parts

Page 9 highlights

Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support Dispenser Drawer Area: Detergent and fabric softener may build up in the dispenser drawer. Residue should be removed once or twice a month. I Remove the drawer by first sliding the safety latch to the right, then pulling the drawer out until it stops. Reach back into the left rear corner of the drawer cavity and press down firmly on the lock tab, pulling out the drawer. Lock tab is visible only after drawer has been pulled out I Remove the inserts from the bleach and fabric softener compartments. Rinse the inserts and the drawer with hot water to remove traces of accumulated laundry products. I To clean the drawer opening, use a small brush to clean the recess. Remove all residue from the upper and lower parts of the recess. NOTE: Large amounts of fabric softener residue may indicate improper dilution or that more frequent cleaning is required. I Return the bleach and fabric softener inserts to the proper compartments. Replace the insert, pressing the "X" to lock it in place. Replace the dispenser drawer and run the QUICK WASH cycle without any wash load in the drum. 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48

9
Dispenser Drawer Area:
Detergent and fabric softener may build up in the
dispenser drawer. Residue should be removed once or twice a month.
Remove the drawer by first sliding the safety latch to the right, then pulling
the drawer out until it stops. Reach back into the left rear corner of the
drawer cavity and press down firmly on the lock tab, pulling out the drawer.
Remove the inserts from the bleach and fabric softener compartments.
Rinse the inserts and the drawer with hot water to remove traces of
accumulated laundry products.
To clean the drawer opening, use a small brush to clean the recess. Remove
all residue from the upper and lower parts of the recess.
NOTE:
Large amounts of fabric softener residue may indicate improper dilution or that more
frequent cleaning is required.
Return the bleach and fabric softener inserts to the proper compartments.
Replace the insert, pressing the “X” to lock it in place. Replace the dispenser
drawer and run the QUICK WASH cycle without any wash load in the drum.
Lock tab is visible only after drawer
has been pulled out
Consumer Support
Troubleshooting Tips
Operating Instructions
Safety Instructions
Installation Instructions