Genie ChainLift 600 Owner's Manual - Page 15

3 WALL CONSOLE INSTALLATION WARNING Verify there is NO power to the opener before installing wall console wires and wall console. CAUTION Staples which are too tight can cut or pinch wires. Cut or pinched wires can cause the wall console to stop working. When using the insulated staples, make sure you fasten them only as tightly as needed to hold the wire snugly. WARNING Use of any other wall control can cause the door to operate unexpectedly and the light not to work. Use only the included wall button. NOTE: For Wall Console,wire and insulated staples locate Bags 6 and 7 from Box 2. 1. Wall Console location. • Wall Console location should be in direct sight of door. • It should be at least five feet (5') above floor to prevent small children from operating door. • It must be away from any moving parts. (You should NOT be able to reach the garage door while standing at Wall Console.) • Wall Console board screw connections are polarized. 2a. Wiring (If pre-wired). • Locate wall console pre-wired wire ends (Fig. 3-1). (They should be located within the guidelines mentioned above.) • Split and strip ends of wire (Fig. 3-2). • Fasten wire to wall console board screws on back of wall console. - Striped wire to the B (plus) terminal. - White wire to the W (minus) terminal. 2b. Wiring (If NOT pre-wired). • Pick a convenient location for mounting wall console using the guidelines mentioned above (Fig. 3-1). • Run wire from wall console to power head (Fig. 3-1). • Split and strip ends of wire (Fig. 3-2). • Fasten wire to control board screws on back of wall console. - Striped wire to the B (plus) terminal. - White wire to the W (minus) terminal. FOR HELP-1.800.354.3643 OR WWW.GENIECOMPANY.COM Wire from power head to wall console. Wall console Separate entry door "Entrapment" warning label EXAMPLE ONLY! This is an example of wire routing when NOT pre-wired. Your wire routing may be different. FIG.3-1 Wall Console wire routing 2" White 1/2" W B or BStlaricpked FIG. 3-2 Splitting and stripping. PN# 3642036534, 02/26/2010 REV. 1 15