Gigabyte C7V7-CSI Manual - Page 25

English Virus Warning If it is set to enable, the category will flash on the screen when there is any attempt to write to the boot sector or partition table of the hard disk drive. The system will halt and the warning message will appear in the mean time. You can run anti-virus program to locate the problem. Enabled Activate automatically when the system boots up causing a warning message to appear when anything attempts to access the boot sector or hard disk partition table. Disabled No warning message to appear when anything attempts to access the boot sector or hard disk partition table. (Default value) BIOS Flash Protection This feature allows you determine the states that flash BIOS. Auto BIOS enables flash write access automatically when updating BIOS data/DMI/ESCD. (Default Value) Enabled During POST, DMI/ESCD would not be updated. But flash tools can update BIOS always. CPU L1 & L2 Cache These two categories speed up memory access. However, it depends on CPU / chipset design. Enabled Enabled Cache.(Default Value) Disabled Disalbed Cache. CPU L2 Cache ECC Checking Enabled Enabled CPU L2 Cache ECC Checking.(Default Value) Disabled Disalbed CPU L2 Cache ECC Checking. Quick Power On Self Test If it is set to Enable, BIOS will shorten or skip some check items during POST. Enabled Disabled Enabled quick POST.(Default Value) Normal POST. First / Second / Third Boot Device LS120 Select your boot device priority by LS120. Hard Disk Select your boot device priority by Hard Disk. CDROM Select your boot device priority by CDROM. ZIP100 Select your boot device priority by ZIP100. USB-FDD Select your boot device priority by USB-FDD. USB-ZIP Select your boot device priority by USB-ZIP. USB-CDROM Select your boot device priority by USB-CDROM. USB-HDD Select your boot device priority by USB-HDD. Legacy LAN Select your boot device priority by Legacy LAN. Disabled Disable this function. - 25 - BIOS Setup