Gigabyte G1.Sniper 3 Manual - Page 31
GSATA3 6/7 SATA 6Gb/s Connectors, Controlled by Marvell 88SE9172 Chip, GSATA3 8/9 SATA 6Gb/s - raid
View all Gigabyte G1.Sniper 3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
10) GSATA3 6/7 (SATA 6Gb/s Connectors, Controlled by Marvell 88SE9172 Chip) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The Marvell 88SE9172 chip supports RAID 0 and RAID 1. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. G.QBOFM GSATA3 7 17 7 16 Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND G 11) GSATA3 8/9 (SATA 6Gb/s Connectors, Controlled by Marvell 88SE9172 Chip) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The Marvell 88SE9172 chip supports RAID 0 and RAID 1. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. G.QBOFM Pin No. Definition GSATA3 7 19 7 18 1 GND 2 TXP 3 TXN 4 GND 5 RXN 6 RXP 7 GND G A RAID 0 or RAID 1 configuration requires two hard drives. - 31 - Hardware Installation