Gigabyte G1.Sniper 5 User Manual - Page 74
C. Configuring a RAID array, Create a RAID Array, HBA 0: Marvell 0, Free Physical Disks
View all Gigabyte G1.Sniper 5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
C. Configuring a RAID array Create a RAID Array: Move the selection bar to HBA 0: Marvell 0 and press . Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd. Topology HBA 0 : Marvell 0 Virtual Disks Free Physical Disks HDD 0: ST95005620AS HDD 1: ST95005620AS Information Vendor ID : Device ID : Revision ID : BIOS Version : Firmware Version : PCIe Speed rate : Configure SATA as : Supported Mode : : 1B4B 9230 A0 20291.24369.82.6535 2.3.0.1046 5.0Gbps x2 AHCI Mode RAID 0 RAID 1 RAID10 Capacity Safe Help Marvell RAID on chip controller. ENTER: Operation F10: Exit/Save ESC: Return Figure 2 Under Free Physical Disks, use the key to select the hard drives to be included in the RAID array. The selected hard drive will be marked with an asterisk (*). After selecting the hard drives, press to proceed (Figure 3). Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd. Configure -> Select free disks HBA 0 : Marvell 0 Virtual Disks Free Physical Disks * HDD 0: ST95005620AS * HDD 1: ST95005620AS Information Port ID : PD ID : Type ID : Status : Size : Feature Support : Current Speed : Model : Serial : FW version : 1 1 SATA PD Unconfigured 465.7GB NCQ 3Gb/s 48Bit 3Gb/s ST95005620AS 5YX01W4H SD22 Help Use space bar to select the free disks to be used in the array. ENTER: Operation SPACE: Select F10: Exit/Save ESC: Return Figure 3 Configuring SATA Hard Drive(s) - 74 -