Gigabyte GA-6PXSVL Manual - Page 22
SATA_2_3/SATA_4_5 SATA 3Gb/s Connectors, SATA0_1 SATA 6Gb/s Connectors
View all Gigabyte GA-6PXSVL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
PORT 9) SATA0_1 (SATA 6Gb/s Connectors) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and 1.5Gb/s standard. Each SATA connector supports a single SATA device. When SATA_DOM0/1 jumper are set to 2-3 pin: Pin No. Definition 1 GND 7 1 2 TXP 3 TXN 7 1 4 GND SATA01 5 RXN 6 RXP 7 GND When SATA_DOM0/1 jumper are set to 1-2 pin: Pin No. Definition 1 GND 2 TXP 3 TXN DEBUG PORT DEBUG PORT 4 GND 5 RXN 6 RXP 10) SATA_2_3/SATA_4_5 (SATA 3Gb/s Connectors) 7 P5V The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. 7 1 7 1 SATA_4_5 7 1 7 1 SATA_2_3 Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are configured, the total number of hard drives must be an even number. • A RAID 10 configuration requires four hard drives. (Note) When a RAID configuration is built across the SATA 6Gb/s channels, the system performance of the RAID configuration may vary depends on the devices are connected. - 22 - Hardware Installation