Gigabyte GA-8I915P Dual Graphic Manual - Page 13

Step 3: Use the arrow keys to select VIA RAID Controller(Windows XP)* (Figure 20) and press ENTER. Then it will begin to load the IDE RAID driver from the floppy disk. Windows Setup You have chosen to configure a SCSI Adapter for use with Windows, using a device support disk provided by an adapter manufacturer. Select the SCSI Adapter you want from the following list, or press ESC to return to the previous screen. VIA RAID Controller(Windows 2003 IA32) VIA RAID Controller(Windows XP) VIA RAID Controller(Windows 2000) VIA RAID Controller(Windows NT4) ENTER=Select F3=Exit Figure 20 Step 4: When the screen as shown below appears, press ENTER to proceed with IDE RAID controller driver installation from the floppy disk. The driver installation will be finished in about one minute. Windows Setup Setup will load support for the following mass storage device(s): VIA RAID Controller(Windows XP) * To specify additional SCSI adapters, CD-ROM drives, or special disk controllers for use with Windows, including those for which you have a device support disk from a mass storage device manufacturer, press S. * If you do not have any device support disks from a mass storage device manufacturer, or do not want to specify additional mass storage devices for use with Windows, press ENTER. S=Specify Additional Device Enter=Continue F3=Exit Figure 21 If a message appears saying that one or some files cannot be found, please check the floppy disk or copy the correct IDE RAID driver again from the motherboard driver CD. "*" Please select the driver according to which of the following operating systems you want to install: Windows 2003 IA32, Windows XP, Windows 2000, or Windows NT4. - 13 - VIA VT6410 IDE RAID Drives Configuration