Gigabyte GA-M52LT-D3P Manual - Page 23
IDE IDE Connector, SATA2_0/1 SATA 3Gb/s Connectors
View all Gigabyte GA-M52LT-D3P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
7) IDE (IDE Connector) The IDE connector supports up to two IDE devices such as hard drives and optical drives. Before attaching the IDE cable, locate the foolproof groove on the connector. If you wish to connect two IDE devices, remember to set the jumpers and the cabling according to the role of the IDE devices (for example, master or slave). (For information about configuring master/slave settings for the IDE devices, read the instructions from the device manufacturers.) 40 39 DEBUG PORT DEBUG 2 PORT1 8) SATA2_0/1 (SATA 3Gb/s Connectors) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The NVIDIA® nForce 520LE controller supports RAID 0 and RAID 1. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configur- ing a RAID array. Pin No. Definition 1 GND 2 TXP 3 TXN 1 7 SATA2_1 4 GND 1 7 SATA2_0 5 RXN 6 RXP 7 GND Please connect the L-shaped end of the SATA cable to your SATA hard drive. A RAID 0 or RAID 1 configuration requires at least two hard drives. - 23 - Hardware Installation