Haier HDE5300AW User Manual - Page 9

English 12 inches (30.5cm) clearance between the vent hood and the ground or any other obstruction. The vent flap should be able to move freely, although vertical orientation of the exhaust system is acceptable. Certain extenuating circumstances could affect the performance of the dryer: 1. 2. Only rigid or flexible metal duct work Venting vertically through a roof may should be used. expose the exhaust system to down 3. drafts causing an increase in vent restriction. Running the exhaust system through an uninsulatedarea may cause 4. condensation Compression and faster accumulation of lint. of crimping of the exhaust system will cause an increase in vent restriction. 5. In Canada, that only those foil-type flexible ducts, if any, specifically identified for use with the appliance by the manufacturer shall be used. In the United States, that only those foil-type flexible ducts, if any, specifically identified for use with the appliance by the manufacturer and that comply with the UL Outline for Clothes Dryer Transition Duct, Subject 2158A (2006), shall be used. 6. In Canada, that the exhaust duct shall be 102 mm in diameter. In the United States, the required exhaust duct diameter. The exhaust system should be inspected and cleaned a minimum of every 12 months with normal usage. The more the dryer is used the more often you should check the exhaust system and vent hood for proper operation. Side and Bottom Exhaust For your convenience, your dryer can be exhausted through the side or the bottom. If you need to change the exhaust on the dryer to the side or the bottom of the cabinet, you will need to order the exhaust kit from your Haier dealer or call 1- 800-313-8495 RECOMMENDED MAXIMUMM Exhaust Hood Types Recommended Use only for short run installations No. of 90º elbows 0 1 2 3 Rigid Metal 90 ft. 60 ft. 45 ft. 35 ft. Rigid Metal 60 ft. 45 ft. 35 ft. 25 ft. The total length of flexible metal duct shall not exceed 2.4 m. 8