Haier HLP21N User Manual - Page 24

Troubleshooting

Page 24 highlights

TROUBLESHOOTING WASHER DOES NOT OPERATE • Check that the power cord is plugged into a grounded 3 prong outlet. • Check that the electrical wall receptacle is of proper voltage. • Check if the circuit breaker needs to be reset or if the fuse needs to be replaced. • Check that the washer is not overloaded. Laundry may need to be redistributed to re-balance the load. • Check that the washer lid is properly closed. • The washer pauses in some cycles. This is normal in the Delicate cycle, which has short periods for laundry to soak. You will not hear the washer operating during that period of time. When the soak time ends, the washer will restart automatically. PROBLEMS WITH WATER Water flow is slow or filling takes a long time: • Check to make sure that the water faucet is fully turned on. • Check the water hose to make sure that it is not tangled, kinked, or pinched. Water leaks: • Check that the inlet hose connection at the faucet and washer are tight. • Check that the drain hose connection at the washer is secure and that the drain hose is properly positioned at the drain location. • Check the plumbing or call a plumber. Water will not drain: • Check that the drain hose is properly connected to the washer. • Check the position of the drain hose. In order to drain properly, the top of drain outlet must be at least 311/2" (80 cm) above the floor. • Check that the sink or drain pipe is not clogged. 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39

22
TROUBLESHOOTING
WASHER DOES NOT OPERATE
Check that the power cord is plugged into a grounded 3 prong outlet.
Check that the electrical wall receptacle is of proper voltage.
Check if the circuit breaker needs to be reset or if the fuse needs to be replaced.
Check that the washer is not overloaded. Laundry may need to be redistributed
to re-balance the load.
Check that the washer lid is properly closed.
The washer pauses in some cycles. This is normal in the Delicate cycle, which
has short periods for laundry to soak. You will not hear the washer operating
during that period of time. When the soak time ends, the washer will restart
automatically.
PROBLEMS WITH WATER
Water flow is slow or filling takes a long time:
Check to make sure that the water faucet is fully turned on.
Check the water hose to make sure that it is not tangled, kinked, or pinched.
Water leaks:
Check that the inlet hose connection at the faucet and washer are tight.
Check that the drain hose connection at the washer is secure and that the drain
hose is properly positioned at the drain location.
Check the plumbing or call a plumber.
Water will not drain:
Check that the drain hose is properly connected to the washer.
Check the position of the drain hose. In order to drain properly, the top of drain
outlet must be at least 31°” (80 cm)
above the floor.
Check that the sink or drain pipe is not clogged.