Haier HLP21N User Manual - Page 8

Location Requirements - washer

Get Haier HLP21N PDF manuals and user guides
UPC - 688057395517
View all Haier HLP21N manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

LOCATION REQUIREMENTS • The washer must be installed on a solid floor to minimize vibration during the spin cycle. A concrete floor is best. • The floor should be level with maximum slope of 1" (25 mm) under entire washer. • A suitable location is protected from direct sunlight and heat sources such as radiators, baseboard heaters, or cooking appliances. • Do not install on carpeting. • The location must have a grounded electrical outlet located within 4 ft. (1.2 m) of power cord on the back of the washer. • Water faucet must be present within 3 ft. (0.9 m) of the connection on the washer. • Only connect to cold water tap (faucet). • The water pressure should be between 20 and 100 psi (138 and 690 kPa). WARNING Do not install or operate the washer where it will be exposed to temperatures below 32°F (0°C). Water remaining in the washer will freeze and cause damage to the washer. WASHER DIMENSIONS 29 76.0 cm) 17¼" (43.8 cm) 17 44.7 cm) 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
6
LOCATION REQUIREMENTS
•
The washer must be installed on a solid floor to minimize vibration during the
spin cycle. A concrete floor is best.
•
The floor should be level with maximum slope of 1" (25 mm) under entire washer.
•
A suitable location is protected from direct sunlight and heat sources such as
radiators, baseboard heaters, or cooking appliances.
•
Do not install on carpeting.
•
The location must have a grounded electrical outlet located within 4 ft. (1.2 m) of
power cord on the back of the washer.
•
Water faucet must be present within 3 ft. (0.9 m) of the connection on the
washer.
•
Only connect to cold water tap (faucet).
•
The water pressure should be between 20 and 100 psi (138 and 690 kPa).
WARNING
Do not install or operate the washer where it will be exposed to
temperatures below 32°F (0°C). Water remaining in the washer will
freeze and cause damage to the washer.
WASHER DIMENSIONS
17¹⁹/₃₂
"
(44.7 cm)
17¼
"
(43.8 cm)
29²⁹/₃₂
"
(76.0 cm)