HealthRider H30x Bike English Manual - Page 18

4. Adjust the contrast level of the display if desired. 7. Check the status of the iFit Live module if desired. The currently selected contrast level will also appear in the display. To change the contrast level, press the increase and decrease buttons until the bullet appears next to the word CONTRAST. To check the status of the iFit Live module, press the increase and decrease buttons until the bullet appears next to the words CHECK WIFI STATUS or CHECK USB STATUS. Press the Enter button and then press the increase and decrease buttons repeatedly to select the desired contrast level. Press the Enter button again to save your selection. Then, press the Enter button. After a few seconds, the status of the iFit Live module will appear in the display. To exit this display, press and hold down the Display button for a few seconds. 5. Determine if an iFit Live module is connected to the console. If an iFit Live module is connected to the console, the display will show the words CHECK WIFI STATUS or CHECK USB STATUS. 8. Check for downloads if desired. To check for iFit Live workouts and firmware downloads, press the increase and decrease buttons until the bullet appears next to the words CHECK FOR DOWNLOADS. If no accessory is connected, the display will show the words NO MODULE DETECTED. If no accessory is connected, go to step 9. Then, press the Enter button. The console will then check for iFit Live workouts and firmware downloads. 6. Select an audio setting for the voice of the personal trainer if desired. The currently selected audio setting for the voice of the personal trainer will also appear in the display. 9. Exit the information mode. Press the Display button to exit the information mode. To change the audio setting, press the increase and decrease buttons until the bullet appears next to the words TRAINER VOICE. Then, press the Enter button repeatedly to turn the voice of the personal trainer ON or OFF. 18