HealthRider H90e Elliptical English Manual - Page 23
Maintenance And Troubleshooting
View all HealthRider H90e Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately. To clean the elliptical exerciser, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. HOW TO LEVEL THE ELLIPTICAL EXERCISER OR ELIMINATE FLEXING IN THE FRAME Adjust the position of the Shields (14, 15) until the Discs (12) no longer rub against them, and then tighten the Bolt Sets (88) and the M4 x 16mm Screws (116). HANDGRIP PULSE SENSOR TROUBLESHOOTING If the handgrip pulse sensor does not function properly, see step 5 on page 16. HOW TO ADJUST THE BELT If the elliptical exerciser rocks on your floor during use, turn one or both of the Leveling Feet (98) until the rocking motion is eliminated. 88 14, 15 12 1 95 116 If the pedals slip while you are pedaling, even while the resis- tance is adjusted to the highest set- ting, the belt may need to be adjust- ed. To adjust the 13 belt, first carefully 12 pry off the left Disc Cover (13) using a flat screwdriver. Next, remove the four screws (not shown) from the center of the left Disc (12). Gently rotate the Disc Cover and the Disc away from the elliptical exerciser. 98 If the elliptical exerciser flexes in the center during use, turn the Center Foot (95) until the flexing is eliminated. HOW TO ELIMINATE RUBBING OF THE DISCS See the drawing above. If the Discs (12) rub against the Shields (14, 15) during use, make sure that the Center Foot (95) is installed in the Frame (1). If the Center Foot is installed, loosen the two indicated Bolt Sets (88) and the two M4 x 16mm Screws (116) in each side of the elliptical exerciser. Loosen, but do not remove, the three 1/4" x 19mm Button Screws (114). Insert the shaft of a screwdriver downward between the 47 48 114 96 Idler (47) and the Idler Pulley (48). Pull the top of the screwdriver toward the rear of the elliptical exerciser until the Belt (96) is tight, and then tighten the three Button Screws. Reattach the left disc with the four screws and then reattach the left disc cover. 23