HealthRider Hotel Fitness It9800 Treadmill English Manual - Page 11

not overtighten the Screws.

Get HealthRider Hotel Fitness It9800 Treadmill PDF manuals and user guides View all HealthRider Hotel Fitness It9800 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

9. Connect the pulse wires from the Left and Right Handrail Assemblies (112, 113) to the pulse wires from the 9 113 Console (103). Insert the included ties through the tie 103 blocks attached to the back of the Console Base (109). Loop the ties around the pulse wires, the Upright Wire Tie (116), and the Upright TV Cable (89), then tighten the ties around the wires. Insert all wires and cables into the top of the Upright (93). 112 109 116 93 Pulse Wires Ties 89 93 10. Attach the Console Base Back (107) with nine #8 x 1/2" Screws (88) and two #8 x 3/4" Screws (86) as shown. Do 10 not overtighten the Screws. 88 88 107 88 88 86 86 11. After the incline trainer is placed in the location where it will be used (see HOW TO MOVE THE INCLINE 11 TRAINER on page 13), make sure that both Rear Leveling Feet (38) and the Base Pads (not shown) rest firmly on the floor. If the incline trainer rocks even slightly, turn one of the Rear Leveling Feet clockwise or counter- clockwise until the rocking motion is eliminated. 38 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
11
9.
Connect the pulse wires from the Left and Right Handrail
Assemblies (112, 113) to the pulse wires from the
Console (103). Insert the included ties through the tie
blocks attached to the back of the Console Base (109).
Loop the ties around the pulse wires, the Upright Wire
(116), and the Upright TV Cable (89), then tighten the
ties around the wires.
Insert all wires and cables into the top of the
Upright (93).
10.
Attach the Console Base Back (107) with nine #8 x 1/2"
Screws (88) and two #8 x 3/4" Screws (86) as shown.
Do
not overtighten the Screws.
103
93
116
89
93
Ties
Tie
113
112
Pulse
Wires
107
88
88
86
86
88
88
9
10
11.
After the incline trainer is placed in the location where
it will be used (see HOW TO MOVE THE INCLINE
TRAINER on page 13), make sure that both Rear
Leveling Feet (38) and the Base Pads (not shown) rest
firmly on the floor. If the incline trainer rocks even slightly,
turn one of the Rear Leveling Feet clockwise or counter-
clockwise until the rocking motion is eliminated.
38
11
109