HealthRider Hotel Fitness It9800 Treadmill English Manual - Page 34

TROUBLESHOOTING Most incline trainer problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the back cover of this manual. SYMPTOM: The power does not turn on a. Make sure that the power cord is plugged into a properly grounded outlet (see page 14). b. Make sure that the key is inserted into the console. c. Check the power switch located on the incline trainer near the power cord. Make sure that the power switch is pressed into the on position. c On SYMPTOM: The walking belt slows when walked on a. If the walking belt is overtightened, performance may decrease and the walking belt may be damaged. If the walking belt is properly tightened, you should be able to lift each side of the walking belt 2.5 to 5 cm (1 to 2 in.) off the walking platform. If adjustments need to be made, first remove the key and unplug the power cord. Using a 7/32" hex key, turn both roller adjustment screws counterclockwise 1/4 of a turn. Then, plug in the power cord, insert the key, and use the incline trainer for a few minutes. Be careful to keep the walking belt centered. Repeat until the walking belt is properly tightened. Note: To tighten the walking belt, see step c. on page 35. a 2.5 to 5 cm SYMPTOM: The power turns off during use a. Check the power switch located on the incline trainer near the power cord (see the drawing above). Make sure that the power switch is pressed into the on position. b. Make sure that the power cord is plugged in. c. Remove the key from the console, and then reinsert it. d. Check the walking belt and the walking platform for excessive wear. Replace the walking belt or the walking platform if necessary. Roller Adjustment Screws VMTL b. If the walking belt still slows when walked on, please see the back cover of this manual. e. If the power still turns off during use, please see the back cover of this manual. 34