HealthRider Hotel Fitness It9800 Treadmill English Manual - Page 31

TURNING THE WALKING PLATFORM Both sides of the walking platform are designed to be used as walking surfaces. Inspect the walking platform periodically for wear. If there is any wood showing through the phenolic coating, or if the surface is damaged, the walking platform should be turned over. The walking platform will need to be turned over and the walking belt replaced (see page 32) after every 10,000 to 15,000 miles (16,000 to 24,000 kilometers). Follow the instructions below to turn over the walking platform. 1. Remove the key and unplug the power cord. Remove the 1-4 #8 x 3/4" Screws (16), the #8 x 1/2" Machine Screws (2), and the Front Cover (17). Next, remove the 3/8" x 5" Screw (19) and the 18 3/8" Star Washer (14) from each 2 16 side of the Front Roller (13). 14 13 17 2. Remove the four 3/8" x 1 3/4" Screws (10) and the two 3/8" x 1 1/2" Screws (20). (Note: Be 23 19 20 2 16 very careful to avoid chipping or damaging the phenolic coat- 10 ing on the Walking Platform 18 23 19 14 [23].) Lift the Front Roller (13) and slide it out of the Walking Belt 10 (18). Lift the Walking Platform and the Walking Belt to the position shown by the dotted lines. Slide the Walking Platform out of the Walking Belt, turn it, and then slide it back into the Walking Belt. 3. Lay down the Walking Platform (23) and the Walking Belt (18). Slide the Front Roller (13) back into the Walking Belt. 4. Reattach the 3/8" x 1 3/4" Screws (10) and the 3/8" x 1 1/2" Screws (20). Thread the 3/8" x 5" Screws (19) with the 3/8" Star Washers (14) into the Front Roller (13). Reattach the Front Cover (17) with the #8 x 3/4" Screws (16) and the #8 x 1/2" Machine Screws (2). 5. Next, the Walking Belt (18) will need to be adjusted to the proper tension. Using chalk, make two marks on the Walking Belt exactly 1.25 m (50 in.) apart, as shown in the drawing. 5 18 Tighten both 3/8" x 5" Screws (19, see the drawing above) 13 until the two chalk marks move apart an additional 5 to 6 mm (3/16 to 1/4 in.). As you tighten the Screws, the Front Roller (13) will move. If the Front Roller stops moving, do not further tighten the Screws; please see the back cover of this manual. Make sure to keep the Walking Belt centered. 31