HealthRider Hotel Fitness It9800 Treadmill English Manual - Page 8

ASSEMBLY • Assembly requires two persons. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps. • To identify small parts, see page 7. • Assembly requires the following tools (not included): one 3/8" hex key one 7/32" hex key one Phillips screwdriver To avoid damaging parts, do not use power tools. 1. Place the Base Frame (56) on two pieces of the wood (A) found in the packaging of the incline trainer. Position 1 the wood on each side of the Base Frame behind the feet as shown. Have a second person hold the Upright (93) near the front of the Base Frame (56) as shown. As you insert the Upright (93) into the Base Frame (56), insert the Frame Wire Harness (129) through the bracket on the Upright and into the large hole in the front of the Upright. Be careful to avoid pinching the wire. Align the holes in the Upright (93) with the holes in the Base Frame (56). 2. Locate the Frame Wire Harness (129) and the Upright Wire (116) in the Upright (93) access hole. 2 Connect the Frame Wire Harness (129) to the Upright Wire (116) at the front of the Upright (93). See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CONNECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. 93 Hole 129 56 A 116 129 116 129 93 8