HP 14-ac000 Maintenance and Service Guide - Page 65
Remove the cable from the clips near the battery bay
View all HP 14-ac000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
● WLAN module (see WLAN module on page 41) ● Memory module (see Memory module on page 43) To remove the system board: 1. Remove the display and antenna cables by disconnecting the display cable from the system board (1). 2. Disconnect the antenna cable from the WLAN module (2). 3. (Touch models only) Disconnect the touch cable from the system board (3). 4. Remove the cables from the clips in the middle of the computer (4). 5. Remove the cable from the clips near the battery bay (5). 6. Remove the tape that secures the cables to the computer (6), and then remove the cables from their remaining routing paths. Component replacement procedures 57
●
WLAN module (see
WLAN module
on page
41
)
●
Memory module (see
Memory module
on page
43
)
To remove the system board:
1.
Remove the display and antenna cables by disconnecting the display cable from the system board
(1)
.
2.
Disconnect the antenna cable from the WLAN module
(2)
.
3.
(Touch models only) Disconnect the touch cable from the system board
(3)
.
4.
Remove the cables from the clips in the middle of the computer
(4)
.
5.
Remove the cable from the clips near the battery bay
(5)
.
6.
Remove the tape that secures the cables to the computer
(6)
, and then remove the cables from their
remaining routing paths.
Component replacement procedures
57