HP 3330mfp HP LaserJet 3300mfp Series - User Guide - Page 203
Message, Description, Interpreting the configuration
![]() |
UPC - 088698451328
View all HP 3330mfp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 203 highlights
Message Subnet Mask Default Gateway Config By BOOTP Server or DHCP Server or RARP Server BOOTP/DHCP Server TFTP Server Config File Description The IP subnet mask configured on the print server. During initialization, a temporary value 0.0.0.0 is displayed. Depending on configuration parameters, the print server may automatically assign a usable default value. q Not Specified a subnet mask is not configured. The IP address of the gateway used when sending packets off the local network. Only one default gateway may be configured. During initialization, a temporary value 0.0.0.0 is displayed. If not provided, the IP address of the print server is used. q Not Specified a default gateway is not configured. Identifies how the print server obtained its IP configuration. q BOOTP automatic configuration via a BOOTP server. q BOOTP/TFTP automatic configuration via a BOOTP server and TFTP configuration file. q DHCP automatic configuration via a DHCP server. q DHCP/TFTP automatic configuration via a DHCP server and TFTP configuration file. q RARP automatic configuration via the Reverse Address Resolution Protocol. q User Specified manual configuration via Telnet, the printer's control panel, HP Web JetAdmin, embedded web server, or other method. q Default IP the default IP address was assigned. This address may not be a valid address for your network. q Not Configured the print server was not configured with IP parameters. Verify that TCP/IP is enabled, or check for error status. Displayed if BOOTP, DHCP, or RARP is used for TCP/IP configuration. It specifies the IP address of the system that responds to the print server's request for automatic TCP/IP configuration over the network. q Not Specified the configuration server's IP address could not be determined or was set to zero in the response packet. Displayed during initialization while the print server attempts to obtain its TCP/IP configuration from a BOOTP or DHCP server. The temporary address displayed is 0.0.0.0. q Not Specified the configuration server's IP address could not be determined or was set to zero in the response packet. The IP address of the system where the TFTP configuration file is located. During initialization, the temporary address 0.0.0.0 is displayed. q Not Specified a TFTP server has not been set. The name of the print server's configuration file. The file pathname may be truncated to fit on two lines. q Not Specified a file was not specified in the BOOTP reply from the host. EN Interpreting the configuration page 201
![](/manual_guide/products/hewlettpackard-3300mfp-hp-laserjet-3300mfp-series-user-guide-8798896/203.png)