HP 6127 HP Deskjet 6127 printer - (English) Network User Guide - Page 17

ethernet software installation installing the printer software on a networked computer before installing Before installing the printer software on a networked computer, verify the following: q The printer is set up and powered on. q The ethernet hub or router is powered on and functioning properly. q All computers on the network are powered on and connected to the network. q The printer is connected to the ethernet network. If the printer was previously installed on a computer with a USB cable, disconnect the USB cable from the printer. Use the printer software CD and follow the instructions below to install an ethernet version of the printer driver on the computer. installation steps Follow these steps to install the printer software on a networked computer: 1. Insert the printer software CD in the computer's CD-ROM drive. If the CD does not autoplay, then open the CD in Windows and double-click the setup.exe file. 2. Follow the onscreen instructions and use the following information to complete the installation. r Printer connection: Connected via network r Network setup: Basic network setup for a PC or server If the printer cannot be detected during the installation process, then follow the printer cannot be detected during software installation instructions in ethernet troubleshooting. 3. After the installation has completed, follow the onscreen instructions to print a test page. file:///C|/enu/ug_ethernet_install_dhcp_autoip_fs.html [12/17/2002 1:00:34 PM]