HP A7518B HP StorageWorks SDLT Tape Drive Getting Started Guide - internal mod - Page 25

Step 7: Secure the drive, Mounting hardware used (HP ProLiant)

Get HP A7518B - StorageWorks SDLT 600 Tape Drive PDF manuals and user guides
UPC - 882780125599
View all HP A7518B manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

Step 7: Secure the drive The server latches and side views of your server model may not be exactly the same as shown in the illustrations. Please refer also to you server documentation. Mounting hardware used (HP ProLiant) Ensure that you use the correct mounting rails or locating screws, as described in "Step 4: Attach mounting hardware" on page 15. The server also incorporates a locking mechanism to hold the tape drive in place. 1 Push the tape drive firmly into the bay and make sure the server latch is locked in position, as shown in Figure 8a. 2 Replace the cover on the server. No mounting hardware used (HP AlphaServer) 1 Use the M3 screws provided with the tape drive to secure it in place. Check that the holes in the chassis are aligned with the holes in the sides of the drive and use a regular Phillips screwdriver to secure the M3 screws, as shown in Figure 8b. Position the screws so that they sit in the right-hand holes on the tape drive (holes 1 and 3). 2 Replace the cover on the server. 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
21
Step 7: Secure the drive
The server latches and side views of your server model may not be exactly the same as shown
in the illustrations. Please refer also to you server documentation.
Mounting hardware used (HP ProLiant)
Ensure that you use the correct mounting rails or locating screws, as described in “Step 4:
Attach mounting hardware” on page 15. The server also incorporates a locking mechanism
to hold the tape drive in place.
1
Push the tape drive firmly into the bay and make sure the server latch is locked in position, as
shown in Figure 8a.
2
Replace the cover on the server.
No mounting hardware used (HP AlphaServer)
1
Use the M3 screws provided with the tape drive to secure it in place. Check that the holes in
the chassis are aligned with the holes in the sides of the drive and use a regular Phillips
screwdriver to secure the M3 screws, as shown in Figure 8b. Position the screws so that they
sit in the right-hand holes on the tape drive (holes 1 and 3).
2
Replace the cover on the server.