HP AE370A Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, Ap - Page 117
executing account must have chassis permissions.
UPC - 882780362611
View all HP AE370A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
configDefault 2 Note that configDefault does not completely remove all FCIP tunnels and GbE IP address information. This may be an issue when attempting to use the same information to create new tunnels or modify the existing ones. When issuing configDefault on the Brocade 7500, it persistently disables the ports. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Operands This command has the following operands: -fid FID Specifies the Fabric ID of the logical switch for which to reset the configuration. This operand is valid only in Virtual Fabric mode, and the executing account must have chassis permissions. -chassis Restores the non-persistent chassis configuration to factory defaults. This command requires chassis permissions. -all Restores all non-persistent configuration parameters to factory defaults (switch and chassis parameters). Examples To restore all system configuration parameters to default values: switch:admin> configdefault -all Executing configdefault...Please wait Committing Configuration ...done. See Also snmpConfig, configure, configureChassis, switchDisable, switchEnable Fabric OS Command Reference 89 53-1001186-01