HP AE370A Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, Ap - Page 616
Specifies the Port mode.
UPC - 882780362611
View all HP AE370A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 616 highlights
2 portCfgVEXPort The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Operands This command has the following operands: -a admin Enables or disables the specified port as a VEX_Port. Valid values are 1 (enable as VEX_Port), 2 (disable as VEX_Port and enable as non-VEX_Port). portCfgDefault may also be used to disable VEX_Ports. -f fabricid Specifies the fabric ID. Valid values are 1-128. -r ratov Specifies the R_A_TOV used for port negotiation. Valid values are 2000 120000. This operand is only applicable if the "Fabric Parameter" attribute value is not "Auto Negotiate". -e edtov Specifies the E_D_TOV used for port negotiation. Valid values are 1000 60000. This operand is only applicable if the "Fabric Parameter" attribute value is not "Auto Negotiate". -d domainid Specify the preferred domain ID. For Brocade native mode (-m 0) or McDATA Open Fabric mode (-m 1), valid values are 1-239. For McDATA Fabric mode (-m 2), valid values are 1-31. -p pidformat Specifies the Port ID format. Valid values are 0-native, 1-core, 2-extended edge. This operand is applicable only when port mode is set to 0 (native mode). If port mode is not "Brocade Native", the Port ID format displays as "Not applicable". -t fabric_parameter Enables or disables negotiation of the fabric parameters. Valid values are: 1-enable, 2-disable. -m port mode Specifies the Port mode. The -m option enforces the same port mode for all the ports connected to the same edge fabric. If the -m option is selected, the port mode is compared to the online ports. If the modes are different, an error message is displayed, and the command fails. Valid values are as follows: 0 Brocade Native mode. 1 McDATA Open Fabric mode. 2 McDATA Fabric mode. 3 MCDATA fabric legacy mode. Note that this mapping between mode values and modes is NOT the same as the mapping used when setting interoperability modes with the interopMode command. Examples To display the VEX_Port configuration of port 2/16: switch:admin> portcfgvexport 2/16 Port 2/16 Admin: State: Pid format: Edge Fabric ID: Front Domain ID: info enabled OK core(N) 16 160 588 Fabric OS Command Reference 53-1001186-01