HP AE370A Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, Ap - Page 175
parameter is specified with this operand, the CTC must be hosted on the local
UPC - 882780362611
View all HP AE370A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 175 highlights
cryptoCfg 2 --manual_rekey -all Performs a manual re-keying of all encrypted disk LUNs in the encryption group. This operation may take an extended period of time. --resume_rekey Resumes a suspended re-key session for a specified disk LUN at the termination point. A re-key session may terminate prematurely due to unrecoverable medium or hardware errors. When a re-key session terminates prematurely, the system logs CRITICAL RAS Log and re-key operation failure status messages. You must take corrective action to clear all error conditions that caused the re-key failure before resuming a suspended re-key session. All DEK or HA cluster members must be online and reachable for this operation to succeed. crypto_target_container_name Specifies the name of the CTC to which the LUN belongs. LUN_Num Specifies the number of the LUN to be re-keyed. Use --show -container for a list of LUN numbers associated with the specified CTC. initiator_PWWN Specifies the initiator port WWN for the specified LUN. --discoverLUN Performs LUN discovery. This command discovers and displays all LUNs that are discoverable by the initiators of a specified CTC. This command is valid only on the node that hosts the CTC. The following operand is required: crypto_target_container_name Specifies the name of the CTC. --show -container Displays all CTCs in the encryption group. This command is valid on all nodes. The following operands are supported: -all -cfg Displays the configuration for all containers in the encryption group. -all -stat Displays the runtime status for all containers hosted on the local node only. crypto_target_container_name -stat | -cfg Displays information for the specified CryptoTarget container. If the -stat parameter is specified with this operand, the CTC must be hosted on the local node. --show -tapepool Displays configuration information for specified tape pools when used with the -cfg option. Displays runtime status information for specified tape pools when used with the -cfg option. This command is valid on all nodes. The following operands are supported: -all -cfg Displays configuration information for all configured tape pools in the encryption group. -all -stat Displays runtime status information for all configured tape pools in the encryption group. -label pool_label | -num pool_num Displays tape pool configuration or runtime status information for a single tape pool specified either by a tape pool label or a number. These operands must be used with either the -stat or the -cfg option. Fabric OS Command Reference 147 53-1001186-01