HP CM6030 Service Manual - Page 488
Control-panel messages continued, Table 7-4
UPC - 883585780983
View all HP CM6030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 488 highlights
Table 7-4 Control-panel messages (continued) Control panel message Description Recommended action 13.05 Paper Late Jam Between Sensors D The leading edge of the paper stopped and F between the registration sensor (D) and the fuser-output sensor (F). Follow the onscreen instructions to locate and remove the paper or obstruction. See Figure 7-4 Paper-path sensors on page 511 to determine the location of the sensor originating the failure. 13.06 Paper Jam In Fuser The paper stopped at the fuser-output sensor Follow the onscreen instructions to locate (F). and remove the paper or obstruction. See Figure 7-4 Paper-path sensors on page 511 to determine the location of the sensor originating the failure. 13.10 Paper Late Jam In Duplex Area Sensors F - G The leading edge of the paper stopped between the output sensor (F) and switchback sensor (G). Follow the onscreen instructions to locate and remove the paper or obstruction. See Figure 7-4 Paper-path sensors on page 511 to determine the location of the sensor originating the failure. 13.11 Paper Stop Jam In Duplex Area at The paper stopped at the switchback-jam Sensor G sensor (G). Follow the onscreen instructions to locate and remove the paper or obstruction. See Figure 7-4 Paper-path sensors on page 511 to determine the location of the sensor originating the failure. 13.12 Paper Late Jam In Duplex Area Sensors H - D The duplex refeed paper stopped between the duplexer-delivery sensor (H) and the registration sensor (D). Follow the onscreen instructions to locate and remove the paper or obstruction. See Figure 7-4 Paper-path sensors on page 511 to determine the location of the sensor originating the failure. 13.12.11 Finisher stay jam at either PI33 or PI34 when engine powered on. When the engine is powered on, the finisher's upper-feed-path-entry sensor (PI33) or the upper-feed-path-exit sensor (PI34) is activated suggesting that there is paper in the upper paper path of the finisher at sensors PI33 or PI34. Signal generated from PI33 (upper-feedpath-entry sensor) and PI34 (upper-feedpath-exit sensor) To locate these sensors, see Detect jams in the stacker unit on page 726. 1. Open the top door and remove any media in the paper path (media detected at PI33). 2. Raise the upper paper path (exit) delivery rollers and remove any media in the paper path (media detected at PI34). 3. Check these sensors for obstructions. Verify that the sensor flags are not damaged, move freely, and are correctly aligned with the sensor body and properly mounted. Also check wiring and connectors for damage or loose connections. 442 Chapter 7 Solve problems ENWW