HP CM6030 Service Manual - Page 90

Table 2-15 Device Behavior menu (continued) Menu item Sub-menu item Sub-menu item Staples Staples Out Offset A4/Letter Staple Fold LTR-R & A4 - R Values None One Left Angled One Right Angled Two Left Two Right Two Top Stop Continue Off On Normal Alternate 1 Alternate 2 -4.0 mm -3.5 mm -3.0 mm -2.5 mm -2.0 mm -1.5 mm -1.0 mm Description default bin for specific types of jobs such as faxes or copies (stapler/stacker only). Sets the default staple selection for documents sent to the device when no staple value is specified. Sets the default behavior when a job specifies stapling and the stapler is out of staples. Stop stops printing if the stapler runs out of staples. Continue allows a job to continue printing even when the device is out of staples. Turns the job offset feature on or off. When job offset is on, each copy of a job is shifted to one side in the output bin in order to keep each copy separate from the others. Controls the speed of the print engine to prevent paper jams by using the stapler buffer. NOTE: The stapler buffer may or may not be used depending on the selected media type or on the sensed media type, if Autosense Mode is enabled. If the Normal setting is enabled, the engine speed will be normal by using the stapler buffer whenever possible. If the Alternate 1 setting is enabled, and the engine is in Autosense Mode, the engine slows down to prevent jams. If the product is NOT in Autosense Mode, the engine performs at normal speed, using the stapler buffer whenever possible. If the Alternate 2 setting is enabled, the engine always slows down to prevent jams, never using the stapler buffer. Adjusts the fold line for Letter and A4 size paper (booklet maker only). 44 Chapter 2 Control panel ENWW